The content of a CCN submission (including all text and figures) can be no longer than two pages. A list of relevant references should be included, but does not count toward the 2 pages. This short summary format is to be used for any submission, talk or poster alike. Prior to the first section of the short summary, there should be the header “Keywords:” followed by a list of descriptive keywords separated by semicolons, all in 9 point font, as shown above.
The text of the paper should be formatted in two columns with an overall width of 7 inches (17.8 cm) and length of 9.25 inches (23.5 cm), with 0.25 inches between the columns. Leave two line spaces between the last author listed and the text of the paper. The left margin should be 0.75 inches, and the top margin should be 1 inch. Use 10 point Times Roman with 12 point vertical spacing, unless otherwise specified.
The title should be 14 point, bold, and centered. The title should be formatted with initial caps (the first letter of content words capitalized and the rest lower case). Each author’s name should appear on a separate line, 11 point bold, and centered, with the author’s email address in parentheses. Under each author’s name list the author’s affiliation and postal address in ordinary 10 point type.
Indent the first line of each paragraph by 1/8 inch (except for the first paragraph of a new section). Do not add extra vertical space between paragraphs.
First level headings should be 12 point, initial caps, bold and centered. Leave one line space above the heading and 1/4 line space below the heading.
Second level headings should be 11 point, initial caps, bold, and flush left. Leave one line space above the heading and 1/4 line space below the heading.
Third level headings should be 10 point, initial caps, bold, and flush left. Leave one line space above the heading, but no space after the heading.
Use standard APA citation format. Citations within the text should include the author’s last name and year. If the authors’ names are included in the sentence, place only the year in parentheses, as in Newell and Simon (1972), but otherwise place the entire reference in parentheses with the authors and year separated by a comma (Newell & Simon, 1972). List multiple references alphabetically and separate them by semicolons (Chalnick & Billman, 1988; Newell & Simon, 1972). Use the “et al.” construction only after listing all the authors to a publication in an earlier reference and for citations with four or more authors.
Indicate footnotes with a number in the text. Place them in 9 point type at the bottom of the column on which they appear. Precede the footnote with a horizontal rule.
Number tables consecutively. Place the table number and title (in 10 point) above the table with one line space above the caption and one line space below it, as in Table 1. You may float tables to the top or bottom of a column, or set wide tables across both columns.
|Table 1: Sample table title.|
|Take smaller||63 - 44 = 21|
|Always borrow||96 - 42 = 34|
|0 - N = N||70 - 47 = 37|
|0 - N = 0||70 - 47 = 30|
Ideally, the figures should make it easy for readers and reviewers to follow the paper. Number figures sequentially, placing the figure number and caption, in 10 point, after the figure with one line space above the caption and one line space below it, as in Figure 1. If necessary, leave extra white space at the bottom of the page to avoid splitting the figure and figure caption. You may float figures to the top or bottom of a column, or set figures across both columns.
Figure 1: This is a figure.
Place acknowledgments (including funding information) in a section at the end of the paper.
Follow the APA Publication Manual for citation format, both within the text and in the reference list, with the following exceptions: (a) do not cite the page numbers of any book, including chapters in edited volumes; (b) use the same format for unpublished references as for published ones. Alphabetize references by the surnames of the authors, with single author entries preceding multiple author entries. Order references by the same authors by the year of publication, with the earliest first.
Use a first level section heading, “References”, as shown in the templates. Use a hanging indent style, with the first line of the reference flush against the left margin and subsequent lines indented by 1/8 inch. Below are example references for a conference paper, book chapter, journal article, dissertation, book, technical report, and edited volume, respectively.
Generating a PostScript file is straightforward for all LaTeX packages we are aware of. When preparing the proposal under LaTeX, it is preferable to use scalable fonts such as Postscript Type 1, Computer Modern. However, quite good results can be obtained with the fonts defined in the style file recommended above (
PDF files with Postscript Type 3 fonts are highly discouraged. PDF and PostScript files utilizing Type 3 fonts are typically produced by the LaTeX system and are lower-resolution bitmapped versions of the letters and figures. It is possible to perform a few simple changes to the configuration or command-line to produce files that use PostScript Type 1 fonts, which are a vector representation of the letters and figures.
For most installations of LaTeX, you can cause dvips to output Type 1 fonts instead of Type 3 fonts by including
-Ppdf option to
dvips. The resulting Postscript file will reference the Type 1 Computer Modern fonts, rather than embedding the bitmapped Type 3 versions, which cause problems with printers.
You may also need to tell
dvips to force letter sized paper with the option:
-t letter. Some LaTeX installations also include
pdflatex, which produces acceptable PDF files as well.